Searching Codes - HANNspree ST42DMSB User Manual

6. During the setting process, only digit keys '0' through '9' are valid inputs, while
other buttons are deemed invalid and do not affect the code setting. For example,
inputting "02" then pressing RETURN does affect the "02" already input.
6.1.3

Searching Codes

If the desired electronic equipment code for setting can not be found on the list in the
appendix, try to use the code-searching function with operating procedures as
follows:
1. Press the corresponding electronic equipment button.The indicator light will come
on for 2 seconds then it goes off; after 3 seconds, the indicator light will come on
again, showing that the setting mode has been entered.
2. Hold the electronic equipment button while pressing POWER, then input mode
codes 9-9-9 in sequence. If the indicator light does not come on again after going off,
the code setting is valid; otherwise the indicator light comes on again after going off
for 6 seconds, prompting user to re-enter mode codes.
3. If setting is successful, the electronic equipment code-searching state is entered
upon releasing the electronic equipment button. The POWER signal of all
manufacturers' codes under the current electronic equipment mode is then
transmitted automatically every 5 seconds.
4. During search, the indicator light will flash when the POWER signal of each
electronic equipment is transmitted. When one cycle of code-searching is complete,
the indicator light will come on for 6 seconds before going off, exiting search mode
automatically.
5. Pressing CH+/CH- during search transmits the next/previous electronic equipment
POWER signal without waiting for 5 seconds, and resets the timer to trigger another
5 seconds interval.
6. Pressing POWER during search exits search mode without saving the new
electronic equipment code; pressing OK during search saves the most recently
searched electronic equipment code and then exits search mode.
7. Buttons other than POWER, OK, and CH+/CH- are not functional during search.
39