Pairing A Remote Control - Avital 4105L Owner's Manual

Pairing a Remote Control

Your system comes with the remote controls already programmed, how-
ever, if you are replacing or adding additional remote controls, they
must be paired to the system prior to operating the system. To pair the
remote, you need to know where the Valet button is located. If the horn
honk is not connected, the main unit LED needs to be visible for visual
confirmation. If you cannot locate or access the main unit, it is recom-
mended that you visit your authorized dealer to pair the remote. The
system is capable of accepting up to four remote controls.
1. Turn key to the ON position
Within 10 seconds, press and release the Valet button once.
2.
Within 10 seconds, press and hold the Valet button. The LED on
3.
the module flashes one time and the horn (if connected) honks to
confirm entry into remote pairing. Do not release the Valet button.
Press the
4.
firm the remote has been paired.
5. Release the Valet button.
Turn the key to OFF position. The horn sounds one long honk (if
6.
connected) to confirm that remote pairing has exited.
The programming routine exits if any of the following occurs:
The ignition is turned off.
•
There is no activity for 30 seconds.
•
The Valet button is pressed too many times.
•
12
button on the remote control. The horn honks to con-
AUX
AUX
AUX
Your 1-way remote coin cell battery can be changed by using a small at blade screwdriver to pry case apart. Replace battery and then snap case together.
© 2016 Directed. All rights reserved.