Table of Contents
Advertisement
Figure 14. Installing pulley on motor.
Figure 15. Installing motor.
Figure 16. Plugging motor to switch.
Mounting Motor
1. Make sure the key is in place in the keyway
on the motor shaft. Align the keyway and
slide the motor pulley onto the motor shaft
as far as it will go. Figure 14.
2. Align pulley with the hole in the back of the
bandsaw body. Slide the motor until mounting
holes align with those in top of the stand.
Figure 15.
3. Secure the motor with the (4)
5
riage bolts,
⁄
flat washers provided.
4. Line the motor pulley up with the lower
wheel pulley and tighten the setscrew with
the Allen
®
wrench provided.
Quick-Connect Cord
To eliminate troublesome wiring, the motor for
your bandsaw has a quick-connect cord that
leads from the motor to the switch. The recep-
tacle end of this cord comes out of the bandsaw
body near the motor and the plug end of the
cord is already attached to the motor.
1. Locate the two plug ends and connect them
together as shown in Figure 16.
2. Do Not become confused with the switch-
to-power cord. It will not fit in the quick-
connect receptacle. Do Not plug the switch-
to-power cord into the power source at this
time.
13
5
⁄
"-18 x 1" car-
16
" hex nuts, lock washers and
16
Do not rely on quick con-
nect cord when making
adjustments to bandsaw.
Always unplug directly at
the power source.
Advertisement
Table of Contents
