Table Stops
The front edge of the table has a T-slot with 2
adjustable stops as shown in Figure 14. They
can be set so that the table motion in the "X" (or
longitudinal) axis is restricted to a specific dis-
tance. This is beneficial for repetitive cuts or hole
placement.
Figure 14. Upper table stops on the G9977.
G9959/G9977 Wood Mill
Saddle Stops
The saddle stops (Figure 15) are used in the
same way as the table stops except that they
restrict the distance of motion in the table along
the "Y" axis.
Figure 15. Saddle stops.
-21-