Yamaha LF225 Owner's Manual page 96

Maintenance
1
1. Oil dipstick
2. Upper mark
3. Lower mark
14. Start the engine and make sure that the
low oil pressure-alert indicator remains
off. Also, make sure that there are no oil
leaks. NOTICE: If the low oil pressure-
alert indicator comes on or if there
are oil leaks, stop the engine and find
the cause. Continued operation with
a problem could cause severe engine
damage. Consult your Yamaha dealer
if the problem cannot be located and
corrected.
[ECM01623]
15. Install the top cowling.
16. Dispose of used oil according to local
regulations.
TIP:
For more information on the disposal of

used oil, consult your Yamaha dealer.
Change the oil more often when operating

the engine under adverse conditions such
as extended trolling.
Changing the engine oil by draining the oil
1. Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01862]
89
2
3
ZMU06918
2. Start the engine. Warm it up and keep
the idle speed for 5-10 minutes.
3. Stop the engine and leave it for 5-10
minutes.
4. Remove the top cowling.
5. Remove the screws.
1
1. Screw
6. Remove the bolts.
ZMU05843
ZMU07956