Receiver (If Equipped); Yamaha Security System Lock And Unlock Mode - Yamaha LF225 Owner's Manual

and then check that it is operating prop-
erly. If the transmitter is not operating
properly, contact a Yamaha dealer.
Keep the remote control transmitter

away from high temperatures and do
not place it in direct sunlight.
Do not drop the remote control trans-

mitter, subject it to strong shocks, or
place any heavy items on it.
Use a soft, dry cloth to clean the remote

control transmitter. Do not use deter-
gent, alcohol, or other chemicals.
Do not attempt to disassemble the re-

mote control transmitter yourself. Oth-
erwise, the transmitter may not operate
properly. If the transmitter needs a new
battery, contact a Yamaha dealer.
If you have lost the remote control

transmitter, consult your Yamaha deal-
er. Keep the least 2 transmitters at all
the time. If you have lost both transmit-
ters, consult your Yamaha dealer.
TIP:
Since the receiver is programmed to rec-

ognize the internal code from this transmit-
ter only, the security system setting can
only be changed with this transmitter. If the
remote control transmitter does not oper-
ate properly, contact a Yamaha dealer.
Have your Yamaha dealer replace the

transmitter battery after 1 year, and every
2 years thereafter as a standard practice.
Refer to local hazardous waste regulations

when disposing of transmitter batteries.
The Yamaha Security System permits reg-

istration of up to 5 remote control transmit-
ters. It is recommended that you have at
least 2 transmitters at all times in case one
is lost or damaged. Consult your Yamaha
dealer for details.
EMU38603

Receiver (if equipped)

The receiver controls the ECM (Electronic
Control Module) to prevent the engine from
starting. Consult your Yamaha dealer for in-
stallation of the receiver.
EMU41612
Yamaha Security System lock and
unlock mode
The Yamaha Security System settings are
selected by pressing the lock or unlock but-
ton on the remote control transmitter briefly.
1
1. Lock button
2. Unlock button
LOCK
When the lock button on the remote control
transmitter is pressed briefly, the beeper
sounds once. This indicates the lock mode is
selected and the engine cannot be started.
The lock mode is selected only when the
main switch is in the "
UNLOCK
When the unlock button on the remote con-
trol transmitter is pressed briefly, the beeper
sounds twice. This indicates the unlock
mode is selected and the engine can be
started.
Components
2
ZMU06456
" (off) position.
32