Advertisement
Available languages
Available languages
NOZZLE MAINTENANCE
See Figure 3.
When shipped, two nozzles are pre-assembled to the sur-
face cleaner. These nozzles are appropriate for use with
gas pressure washers operating at 2500 to 3300 psi with a
maximum flow rate of 3 gpm.
Excessive pump pressure (a pulsing sensation felt while
squeezing the trigger and/or a higher vibration in the surface
cleaner) may be the result of a clogged or dirty nozzle.
n Turn off the pressure washer and shut off the water supply.
With the surface cleaner on the ground, pull the trigger
to release water pressure.
n Disconnect surface cleaner from spray wand.
n Using a fine needle or nozzle cleaning tool (not provided),
free any foreign materials clogging or restricting the
nozzle.
n Using a garden hose, flush debris out of nozzle by back
flushing (running the water through the nozzle backwards
or from the outside to the inside).
NOTE: Never point the nozzle outlet at your face.
n Reconnect the surface cleaner to the spray wand.
n Turn on the water supply and start the pressure washer.
CHANGING THE HIGH PRESSURE FILTER
See Figure 4.
Once you have cleaned the deck nozzles, if the water still
doesn't flow freely from the spray bar, it may be necessary
to replace the high pressure filter.
To replace the filter:
n Turn off the pressure washer and shut off the water supply.
With the surface cleaner on the ground, pull the trigger
to release water pressure.
n Disconnect the surface cleaner from the spray wand.
n Place a flat head screwdriver in the slot of the high pres-
sure filter inside the cleaning deck inlet plug, shown in
figure 4, and turn counterclockwise. This will unscrew the
filter and allow it to be removed.
n Once the filter is removed from the inlet plug, replace it
with a new filter (not included).
n Using a flat head screwdriver, turn the filter clockwise until
it can no longer be seen over the top of the inlet plug.
REPLACEMENT PARTS
The following replacement parts may be ordered by calling
our customer service department at 1-866-340-3912:
Inlet Plug ............................................................678557001
High Pressure Filter ...........................................308103010
SPRAY
BAR
NOZZLE
FINE NEEDLE
HIGH PRESSURE
FILTER
Fig. 3
CLEANING DECK
INLET PLUG
Fig. 4
Advertisement
