Transportation And Storage; Pump Lubrication; Nozzle Maintenance - Ryobi RPW190BL-G Operating Instructions Manual

TRANSPORTATION AND STORAGE

CAUTION
Mind the weight of the product when
selecting the storage location and during
transportation to prevent accidents or
injuries.
■ Stop the product, disconnect from the
power supply, and allow the product to cool
down. Disconnect the product from the
water supply before storing or transporting.
Never place the product in any position
other than upright.
■ Clean all foreign materials from the product.
Store it in a cool, dry, and well-ventilated
place that is inaccessible to children. Keep
away from corrosive agents such as garden
chemicals and de-icing salts. Do not store
the product outdoors.
■ Remove water from all hoses and the
pump, and empty the detergent tank before
storing the product.
■ For transportation in a vehicle, secure the
product against movement or falling to
prevent injury to persons or damage to the
product.
WARNING
Only store the product indoor. Storing in
an area with temperature below 0°C will
damage the product.
MAINTENANCE
WARNING
Use only original
replacement parts,
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
WARNING
Servicing requires
knowledge and should be performed only by
a qualified service technician. For service,
have the product serviced by an authorised
service centre only. When servicing, use
only original replacement parts.
4
manufacturer's
accessories, and
extreme care and
■ Turn off the product, disconnect from the
power supply, allow the product to cool
down, and disconnect the product from the
water supply:
● before cleaning the product
● before maintaining the product
● before replacing spare parts
■ You may make adjustments or repairs
described in this manual. For other repairs,
contact an authorised service centre.
■ Regularly inspect and maintain the high
pressure washer for safe operation. RYOBI
recommends inspecting the product every
3 months.
■ Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure the
product is in safe working condition. Any
part that is damaged should be properly
repaired or replaced by an authorised
service centre.

PUMP LUBRICATION

The pump on this unit is lubricated with a
sufficient amount of high grade lubricant for
the life of the unit under normal operating
conditions. Therefore, no further lubrication is
required.
PUMP MAINTENANACE
Routinely make a visual inspection of the
pump. If you notice any leaking of lubricant
around the pump seals, take the pressure
washer to an authorized service center for
repair.
There are no user serviceable parts to the
pressure washer pump. Any attempt to service
or alter the pump may damage the pressure
washer and void your product warranty.

NOZZLE MAINTENANCE

WARNING
NEVER remove nozzles without first turning
off the motor, disconnecting from power
supply, relieving the water pressure in the
trigger handle, and locking the lock out on
the trigger handle. NEVER point the nozzle
at your face or at others. Failure to follow
these instructions could result in an eye
injury or other serious personal injury.
Excessive pump pressure (a pulsing sensation
felt while squeezing the trigger) may be the