Surface Grates - Jenn-Air JGC3215GS0 Use & Care Manual

Burner ports: Check burner flames occasionally for proper size
and shape. A good flame is blue in color, not yellow. Keep this
area free of soil and do not allow spills, food, cleaning agents or
any other material to enter the burner ports.
A
B
Standard burner
A. Low flame
B. High flame
A
Dual flame burner
A. Simmer flame
B. High flame
To Clean:
IMPORTANT: Before cleaning, make sure all controls are off
and cooktop is cool. Do not use oven cleaners, bleach or rust
removers.
1. Remove the burner cap from the burner base and clean
according to the "General Cleaning" section.
2. Clean the gas tube opening with a damp cloth.
3. Replace burner bases and burner caps.
IMPORTANT:
Be sure that the igniter electrode aligns with the slot or
■
notch in the burner base. The igniter electrode is ceramic
and could break during installation of the burner base.
A. Burner cap
B. Igniter electrode
C. Burner base
Be sure that the cap is properly positioned on the burner
■
and that you have placed the cap on the correct burner.
The ring on the bottom of the cap will align with the tabs
on the burner. Do not interchange caps.
6
4. Turn on the burner. If the burner does not light, check burner
cap and base alignment. See "Burner installation" in the
"Sealed Surface Burners" section. If the burner still does not
light, do not service the burner yourself. Contact a trained
repair specialist.
The surface grate is positioned correctly when the thick ribs
form a frame around the outer edge and the thin ribs are located
across the middle. All burners will be centered with the burner
B
openings in the grates. See the following illustration.
A. Correct
B. Incorrect

Surface Grates

A B
C
A. Thick ribs
B. Thin ribs
C. End grates
A B
C