Alcatel-Lucent OAW-AP277 Installation Manual page 6

EU Statement:
Lower power radio LAN product operating in 2.4 GHz and 5 GHz bands. Please refer to the AOS-W User Guide
for details on restrictions.
Produit réseau local radio basse puissance operant dans la bande fréquence 2.4 GHz et 5 GHz. Merci de vous
referrer au AOS-W User Guide pour les details des restrictions.
!
CAUTION
Low Power FunkLAN Produkt, das im 2.4 GHz und im 5 GHz Band arbeitet. Weitere Informationen bezlüglich
Einschränkungen finden Sie im AOS-W User Guide.
Apparati Radio LAN a bassa Potenza, operanti a 2.4 GHz e 5 GHz. Fare riferimento alla AOS-W User Guide per
avere informazioni detagliate sulle restrizioni.
Pre-Installation Network Requirements
After WLAN planning is complete and the appropriate products and their placement have been
determined, the Alcatel-Lucent switch(s) must be installed and initial setup performed before the
Alcatel-Lucent APs are deployed.
For initial setup of the switch, refer to the AOS-W Quick Start Guide for the software version installed
on your switch.
Pre-Installation Checklist
Before installing your AP, be sure that you have the items listed below:
Gigabit Ethernet cable of required length

IEEE 802.3at compliant PoE source or AC power source

Alcatel-Lucent Mobility Controller configured and installed on the network

Layer 2/3 network connectivity to your AP

One of the following network services:

Alcatel-Lucent Discovery Protocol (ADP)

DNS server with an "A" record

DHCP Server with vendor specific options

Alcatel-Lucent, Inc. in compliance with governmental requirements, has designed the OAW-AP277 such that
only authorized network administrators can change configuration settings. For more information about AP
configuration, refer to the AOS-W Quick Start Guide and AOS-W User Guide.
Access points are radio transmission devices and as such are subject to governmental regulation. Network
administrators responsible for the configuration and operation of access points must comply with local
!
broadcast regulations. Specifically, access points must use channel assignments appropriate to the location in
CAUTION
which the access point will be used.
Verifying Pre-Installation Connectivity
Before you install APs in a network environment, make sure that the APs will be able to locate and
connect to the switch when they are powered on.
Specifically, you must verify the following conditions:
When connected to the network, each AP is assigned a valid IP address.

6 OAW-AP277 Outdoor Access Point
| Installation Guide