Alcatel-Lucent OAW-AP277 Installation Manual page 10

Figure 9 Attaching the AP to the Mounting Holder (Completed)
The inclination of the AP (mounted to the mounting holder) can be adjusted up to +/-45 degrees by
inserting the M6x20 screw (included in the package) into the different holes on the mounting holder.
8. Use the cable tie to fasten the cables on the bracket.
Mounting the AP to a Pole
1. Begin by attaching the mounting bracket to the pole as shown in
a. Pass a hose clamp through the two slots on the mounting bracket, attach the mounting bracket
to the pole and tighten the clamp using a screw driver to twist its screw head.
b. Use another hose clamp through the other two slots on the mounting bracket and tighten the
clamp.
The hose clamps provided with the AP have an optimal pole diameter range of 4" to 6" (100 to 150mm).
Outside of that, longer or shorter clamps may be required.
Figure 10 Attaching the Mounting Bracket to a Pole
2. Use the M10x30 screw (with washer) and M10 nut included in the package to attach the mounting
holder to the mounting bracket as shown in
10
Figure
Figure 11.
OAW-AP277 Outdoor Access Point
10.
| Installation Guide