Alcatel-Lucent OAW-AP277 Installation Manual page 4

Table 2 OAW-AP277 LED Meanings during Operation
LED
System LED
USB Console Port
The USB Micro-B console port allows you to connect the AP to a terminal or a laptop for direct local
management. Use the included USB console cable to connect the AP. You can download the
necessary driver for USB-UART adapter from https://service.esd.alcatel-lucent.com.
Use the following setting to access the terminal:
Table 3 Console Settings
Baud Rate Data Bits Parity
9600
Ethernet Ports
OAW-AP277 is equipped with two10/100/1000Base-T (RJ-45) Gigabit Ethernet ports (WAN and LAN
port) for wired network connectivity. The WAN port supports 802.3at Power over Ethernet (PoE),
accepting 48 VDC (nominal) as a standard defined Powered Device (PD) from a Power Sourcing
Equipment (PSE) such as a PoE midspan injector.
These ports have RJ-45 female connectors with the pin-outs shown in
Figure 3 Gigabit Ethernet Port Pin-Out
Reset Button
The reset button can be used to return the AP to factory default settings. To reset the AP:
1. Power off the AP.
2. Press and hold the reset button using a small, narrow object, such as a paperclip.
3. Power-on the AP without releasing the reset button. The system LED will flash within 5 seconds.
4. Release the reset button.
The system LED will flash again within 15 seconds indicating that the reset is completed. The AP will
now continue to boot with the factory default settings.
4
Color/State
Solid Red
One blink off every 3
seconds
Two quick blink off 0.5
seconds apart cycled every
3 seconds
Stop Bits
8 None 1
Signal Name
RJ-45 Female
Pin-Out
BI_DA+
1
BI_DA-
2
BI_DB+
3
BI_DC+
4
BI_DC-
5
BI_DB-
6
BI_DD+
7
BI_DD-
8
Meaning
General fault
Radio 0 fault (5 GHz)
Radio 1 fault (2.4GHz)
Flow Control
None
Function
Bi-directional pair +A, POE Negative
Bi-directional pair -A, POE Negative
Bi-directional pair +B, POE Positive
Bi-directional pair +C, POE Positive
Bi-directional pair -C, POE Positive
Bi-directional pair -B, POE Positive
Bi-directional pair +D, POE Negative
Bi-directional pair -D, POE Negative
OAW-AP277 Outdoor Access Point
Figure 3.
| Installation Guide