Problem
Lines flash and light up
after switching on: .
Program selection is
not possible.
and light up after
a program has been
cancelled, a signal
sounds.
and another number
combination flash after
a program has been
cancelled, a signal
sounds.
: lights up and the
program has been
cancelled, a signal
sounds.
Frequently Asked Questions
Possible cause and solution
Access via a PIN code has been activated.
See "Programmable functions", " PIN code".
An excessive amount of lint has built up.
Clean the lint filters.
Clean the plinth filter.
Clean the airways: the area underneath the plinth
filter and the heat exchanger.
See "Cleaning and care".
To switch off:
Switch the dryer off and then on again.
There is no obvious cause.
Switch the dryer off and then on again.
Start a program.
If the program is interrupted again and an error
message appears, there is a fault. Contact Miele
Technical Service.
The laundry is unevenly distributed or has rolled up.
Untangle the laundry and remove a few items if
necessary.
Switch the dryer off and then on again.
Start a program.
47