Installation Of The Cabinet; Space For Outside Air Flow - LG JW-Q18WUXA1 Owner's Manual

Installation of the Cabinet

1
Prepare the hole in the wall so that the
bottom of the unit is well supported, the top
has minimum clearace and the air inlet
louveres have clearance as shown. Holes
from the outside through to the cavity should
be sealed. The unit should slope down
towards the rear by about 10~15 mm to allow
water formed during operation to drain.
2
Install the cabinet into the wall and secure.
Ensure the foam seals are not damaged.
Flash, seal or fill gaps around the inside
and outside to provide satisfactory
appearance and protection against the
weather, insects and rodents.
NOTE
• Unit may be supported by a solid frame from
below or by a hanger from a solid overhead
support.
FLASH OR SEAL AROUND EXTERNAL WALL FRAME
OR ARCHITRAVE
TIMBER FRAMED
WALL OR PARTITION
Preferred method of installation into
a timber framed wall, partition or window.
DRAIN CHUTE
FLASH OR SEAL AROUND EXTERNAL
WALL FRAME OR ARCHITRAVE
ALTERNATIVELY, BRACKETS AS
ILLUSTRATED BELOW MAY BE USED.

Space for Outside Air Flow

AIR IN
AIR OUT
100 mm minimum
OPTION A
45° BRICK CUT AWAY
TO CLEAR LOUVRES
FRONT
BRICK
WALL
100 mm
TOP VIEW
AIR IN
LOUVRE
AIR OUT
OPTION B
11 EN
INSTALLATION
AIR IN
45° BRICK CUT AWAY
TO CLEAR LOUVRES
110~180 mm
BRICK
WALL
AIR IN
100 mm