Engine Oil; Checking; Changing - Coleman CT200U-EX V Owner's Manual

Engine Oil

The proper amount and grade of
engine oil will have a great impact
on the life of the engine. Checking
the oil daily and changing the oil as
listed in the maintenance schedule
is the most important maintenance
procedure for the engine.
Checking the engine oil
1. Make sure the Mini Bike is on level
ground.
2. Check engine oil level by remov-
ing the oil fill plug/dipstick (1)
located on bottom front left front
side of the engine.
3. If engine oil is low, add oil until
oil is at edge of fill hole (2). Use the
correct grade of oil as listed in this
manual. Do not over or under fill
engine with oil, this could damage
the engine.
Changing the engine oil
1. Make sure engine is warm before
attempting to drain the oil. A warm
engine will help the oil drain quicker.
2. Remove the oil fill plug (1)
3. Remove the drain bolt (3) located on
the bottom of the engine.
4. Allow the oil to drain in an appro-
priate container. Note: Dispose of
oil at an oil recycle center.
5. Install the drain plug and fill with the
appropriate type of oil as listed in this
manual. This mini bike takes .63qt. (.6L)
of engine oil.
6. Re- install fill cap, Start engine and
allow to run for a few minutes,
Re-check oil level and fill accordingly.
MAINTENANCE
!
New and used oil can be
hazardous
Children and pets can be
harmed by swallowing new or
used oil. Continuous contact
with used engine oil has been
found to cause skin cancer in
laboratory animals
Always keep new or used oil
away from children and pets.
20
WARNING
1
1
3
2