Whirlpool UDT518SAHP User Instructions page 12

OPTION SELECTIONS
Runs dishwasher at a later time. Select a wash
cycle and options. Each time you press the
Delay keypad, it will display the next available
delay time. Press START/RESUME, then close
the door firmly.
NOTES:
(varies by
The dishwasher remembers the last delay
model) ■
you selected. To reset the delay time to
something other than what is displayed,
continue to press the Delay keypad until the
desired delay time is reached.
Anytime the door is opened (such as, to
■
add a dish), the Start/Resume keypad
must be pressed again to resume delay
countdown.
Raises main wash temperature to improve
cleaning for loads containing tough, baked-on
food.
Dries dishes with heat. This option, with the
use of rinse aid, will provide better drying
performance. Plastic items are less likely to
deform when loaded in the top rack. Use Heat
Dry for optimum dry performance. Turn the
Heat Dry option off for air dry.
Extended Dry lengthens the time that Heat Dry
is active. This option with the use of rinse aid will
provide better drying performance.
Sanitizes dishes and glassware in accordance
with NSF International NSF/ANSI Standard
184 for Residential Dishwashers. Certified
residential dishwashers are not intended
for licensed food establishments. Only
(location of
sanitizing cycles have been designed to
"Sanitized"
meet the requirements of the NSF/ANSI 184
indicator
performance standard for soil removal and
varies by
for sanitization efficacy. There is no intention,
model)
either directly or indirectly, that all cycles on a
NSF/ANSI 184 certified dishwasher meet the
NSF/ANSI 184 performance standard for soil
removal and for sanitization efficacy.
At end of the cycle, the "Sanitized" indicator
will glow. If your load did not properly sanitize,
the indicator will flash at the end of the cycle.
This can happen if the cycle is interrupted
or if the water does not reach the required
temperature. The light goes off when you open
and close the door or press CANCEL.
Avoids unintended use of dishwasher between cycles, or cycle and option changes during a cycle.
To turn on Lock, press and hold CONTROL LOCK for 3 seconds. Control Lock light will stay on for a short time,
indicating that it is activated and all keypads are disabled. If you press any keypad while your dishwasher is locked,
light flashes 3 times. Dishwasher door can still be opened/closed while the controls are locked.
To turn off Lock, press and hold CONTROL LOCK for 3 seconds. Light turns off.
12
OPTIONS CAN BE WHAT IT
SELECTED DOES
WITH
Available with Delays start of a
any cycle cycle up to 24
hours.
Sensor Raises the
Heavy main wash
Normal
temperature to
Soak & Clean 135°F (57°C).
Sensor Uses heating
Heavy element to
Normal
speed drying
Soak & Clean times. Heat
Dry option
defaults to on
when any cycle
is selected,
except for
1-Hour Wash.
Sensor Raises the
Heavy
main wash
Normal temperature
to 135°F
(57°C) and
the final rinse
temperature to
156°F (69°C).
ADDED ADDED
TIME TO WATER
CYCLE GALLONS
(LITERS)
N/A N/A
0:05 to 0:13 0 to 3.86
(0 to 14.6)
0:08 to 0:46 0
0:05 to 1:06 0 to 3.86
(0 to 14.6)