Clone - Yaesu FTM-3207D Advance Manual

The FTM-3207DR/DE includes a convenient "Clone" feature, which allows the memory
and configuration data from one transceiver to be transferred to another FTM-3207DR/
DE.
This can be particularly useful when configuring a number of transceivers for a public
service operation.
Here is the procedure for cloning data from one radio to another:
1. Turn both radios OFF.
2. Connect the user-constructed cloning cable between the MIC jacks of the two radios.
3. Press and hold in the [ MHz ( SETUP )] key
while turning the radios ON. Do this for both
radios (the order of switch-on does not mat-
ter). "CLONE" will appear on the displays of
both radios when the Clone mode is suc-
cessfully activated in this step.
4. On the Destination radio; press the [ MHz (-
SETUP )] key ("-- --WAIT-- --" will appear on
the display).
5. On the Source radio; press the [ REV ( DW )]
key "-- -- --TX-- -- --" will appear on the
Source radio, and the data from this radio
will be transferred to the destination radio.
6. If there is a problem during the cloning pro-
cess, "ERROR" will be displayed. Check
your cable connections and battery voltage,
and try again.
7. If the data transfer is successful, "CLONE"
will appear on the Source radio display. The
destination radio, to which the data is cop-
ied, will restart automatically.
8. Turn both radios off and disconnect the cloning cable.
VOL
SQL REV D/A M H z
TXPO D W
SETUP
RJ12/6
6 Position 6 Contact
Modular Plug
Pin 3: GND
Pin 1: PTT/CLONE
FTM-3207DR/DE Advance Manual
DIAL
V / M
M W
Pin 1: PTT/CLONE
Pin 3: GND
VOL
SQL REV D/A
TXPO D W
VOL
SQL REV D/A M H z V / M
TXPO D W M W
SETUP
RJ12/6
6 Position 6 Contact
Modular Plug

Clone

DIAL
M H z V / M
SETUP M W
DIAL
23