Table of Contents
Advertisement
GLASS DOOR OVERLAY PANEL — PREPARATION
Create the custom overlay panel using the dimensions
shown in the illustration " Glass door overlay panel and
hinge routing dimensions". Rout shaded areas to a 1/2"
(12 mm) depth as shown.
IMPORTANT: The following graphic shows a custom
panel for a door with the hinges installed on the right-
hand side. If your refrigerator has the hinges installed on
the left-hand side, rotate the custom frame 180° so the
hinge markings will be on the left.
1/4"
(7 mm)
1/8"
(3 mm)
(125 mm)
1/2"
(12 mm)
Glass door overlay panel and hinge routing dimensions
2"
(53 mm)
415/16"
305/8"
(77.75 cm)
171/16"
(43.3 cm)
2113/16"
(55.4 cm)
HANDLE (OPTIONAL)
Custom handles are typically attached to the custom
overlay door panel only.
Refer instructions received with JennAir RISE
NOIR
handle kits to install these handles on custom
TM
wood panels.
Custom handle needs to be installed on the door panel
with countersunk holes and installed before the custom
overlay door panel has been installed on the refrigerator
door.
233/4"
(60.3 cm)
and
TM
7
Advertisement
Table of Contents
