Programming Summary for the Answering System
You can program the following functions using the handset near the
base unit. Make sure the unit is in the standby mode initially.
(FUNCTION/EXIT/CH)
Press
Ö
Ñ
Press
or
to select "Program", and press
key).
Ö
Ñ
Press
or
to select "TAD program", and press
(Yes key).
•"Answering system setting. See base unit." is displayed on the
handset.
The base unit display shows programming options. Enter a required
command on the display using the handset dialing buttons. See the
page numbers for details.
0=Day and time
1=Remote code
2=Number of ring
*
5=Recording time
*
FWD/EDIT á
Press
•You can exit the programming mode any time by pressing (FUNCTION/EXIT/CH).
•If you do not press any buttons for 60 seconds, the unit will return to the standby
mode.
•If 6 beeps sound on the base unit during programming, a wrong key was
pressed. Enter the correct number.
•If the handset has lost communication with the base unit, 3 beeps sound and "No
link to base. Place on cradle and try again." is displayed on the
handset.
.
G
G
G
Adjusts the day and time (p. 22).
Sets the remote code (p. 61).
Selects the number of rings (p. 25).
Selects the caller's recording time (p. 24).
*
The display will change every 3 seconds.
G
(Save key).
FWD/EDIT á
(Yes
FWD/EDIT á
21