Table of Contents
Advertisement
Installation
When the metal probes on the probe unit come in to contact with water, a small
amount of electrical charge flows between the probes, which the main unit
recognizes as a water leak.
Note:
R When installing, make sure the battery is inserted properly and the unit cover is
completely closed.
R When installing on a wooden surface, use the included wall mounting adaptors.
When securing the wall mounting adaptors to the wall, use screws (not
double-sided tape).
R Mount the sensor on the stable location where the sensor can be adequately
supported when mounting.
R Do not mount the sensor on a soft material. It may fall down, break or cause
injury.
R Do not mount the sensor on the following places: gypsum board, ALC
(autoclaved lightweight cellular concrete), concrete block, plywood less than
25.4 mm (1 inch) thick, etc.
Installation location
Install the sensor in a basement, kitchen, utility room, or anywhere you want to
detect a water leak. Common installation examples include near a washing
machine, hot water heater, or a location where a water leak has occurred in the
past.
Note:
R The sensor may make false detections when its metal probes are touching the
floor. Mount the probe unit so that its metal probes do not touch the floor.
R Mount the main unit 1 m (3 feet 3 inches) or higher above the floor so that it will
not become wet in the event of a water leak.
For assistance, please visit www.panasonic.com/support
HNS103_(en_en)_1120_ver.010.pdf
11
Setup
11
2014/11/19
19:26:58
Advertisement
Table of Contents
