Table of Contents
Advertisement
Installation
The main unit is installed on a wall, and the probe unit can be installed on a wall or
a floor.
When the metal probes on the probe unit come in to contact with water, a small
amount of electrical charge flows between the probes, which the main unit
recognizes as a water leak.
Probe unit installed on wall
Installation precautions
R The sensor is not designed to be used in situations that require high reliability.
We do not recommend use of the sensor in these situations.
R Panasonic takes no responsibility for any injury or damage caused by the use of
this product.
R When installing, make sure the battery is inserted properly and the main unit
cover is completely closed.
R When installing on a wooden surface, use the included wall mounting adaptors.
Secure the wall mounting adaptors to the wall using screws (not double-sided
tape).
R Mount the sensor on the stable location where the sensor can be adequately
supported when mounting.
R Do not mount the sensor on a soft material. It may fall down, break or cause
injury.
R Do not mount the sensor on the following places: gypsum board, ALC
(autoclaved lightweight cellular concrete), concrete block, plywood less than
25.4 mm thick, etc.
R The sensor may not be able to properly detect a water leak if the water contains
contaminants such as oil, or if the water is frozen (i.e., ice or snow).
Probe unit installed on floor
Setup
11
Advertisement
Table of Contents
