Advertisement
Attaching the monitor with the arm-stand(option)
Support
stand
This monitor's installation surface is compatible with various kinds
of VESA standard stands.
Hole spacing : 100x100 mm
Screw Length : 8~12 mm
English - 16
Surface for
stand
installation
Tighten up screws at the
locations indicated by
arrows.
TROBLESHOOTING
Symptom
Picture is jitterd.
Adjust Clock to set the screen position and adjust
Clock fine until a noise isn't displayed.
No picture.
Check if power switch and computer power switch
are in the on position.
Check if the signal cable is correctly connected to
the video card.
Check if the pins of D subconnector are not bent.
Check if the computer is in the power- saving mode.
POWER LED is not
Check if power switch is in the on position.
lit.
Check if the power cord is correctly connected.
Image is unstable.
Check if the signal cable is suitable to the video card.
Image is not
Adjust Clock or H&V Center to get the proper
centered, too small
image.
or too large.
Picture bounces or a
Keep the devices that may cause electrical
wave pattern is
interference away from the monitor.
present in the
picture.
Picture is blurred.
Adjust Contrast and Brightness.
English - 17
Check
Advertisement
