Page 1
USER’S GUIDE TFT-LCD MONITOR Model No :L523SC...
Page 2
IMPORTANT SAFEGUARDS FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT NOTE : This equipment has been tested and found to comply with the limits for a 1. Read all of these instructions. 12. For added protection for this Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are monitor during a lightning storm, 2.
CONTENTS INTRODUCTION CONTENTS INTRODUCTION Introduction ................1 This manual explains how to correctly install, operate and get the best performance from your monitor. Please read this user’s Product Features ..............2 guide carefully before installing your monitor, then keep it near your monitor for quick reference.
SETUP SETUP PRODUCT FEATURES CONNECTING THE 15 PIN SIGNAL CABLE AND POWER CORD The monitor is designed for use in a small work area. 1. Turn off the computer and monitor. The convenient and user-friendly on-screen display allows for easy and accurate adjustments of screen size, position and 2.
OPERA TION & ADJUSTMENT OPERA TION & ADJUSTMENT CONNECTING THE OTHERS CONTROL PANEL 1. Plug the connector to the BNC IN/OUT port on the rear of POWER Indicator POWER the monitor. Shows both normal operation Switches the monitor on and power management status and off.
Page 6
HOT KEY KEY PROCESS AUTO MENU When there is no OSD, if you press this AUTO T RACK IN G AUTO button, you can use the best display performance fit for a current mode. 1024 x 768 75Hz 1024 x 768 75Hz 1024 x 768 75Hz Color...
Page 7
OSD FUNCTIONS WITH USING PC ADJUSTMENT PROCEDURE COLOR Adjust the contrast of image, the difference between Is the H.Size CONTRAST Adjust the control. light and dark areas on the screen. CLOCK proper? Adjust the brightness of image. BRIGHTNESS Perform the AUTO Adjust the gamma correction.
Page 8
OSD FUNCTIONS WITH USING VIDEO OSD MENU PICTURE Select language for OSD. LANGUAGE Adjust the contrast of image. CONTRAST Adjust the OSD position horizontally (left or right) OSD H &V Adjust the brightness of image. BRIGHTNESS and vertically (up or down). POS.
SPECIFICA TIONS SPECIFICA TIONS SELF DIAGNOSIS Panel Size 15-inch(38 cm) diagonal If there is no image, the Self Diagnosis screen will be displayed. Pixel Pitch 0.297 x 0.297 mm Self Diagnosis function checks if the status of the monitor screen Viewing Angle 65°(Right/Left) is No Signal, Out of range or None support.
ACTOR Y PRESET TIMINGS ACTOR Y PRESET TIMINGS VESA MODES Weight-net/gross 4.2 / 5.5 Kg (9.26 / 12.1 Lbs) Resolution Mode H.Freq (KHz) V.Freq (Hz) Remark Power Saving EPA, VESA DPMS, Nutek Compliant (dots lines) Tilt Range 5° forward, 30° backward 60Hz 31.5 Non-interlaced...
CHANGING THE ST CHANGING THE ST Removing Original Stand ATTACHING THE MONITOR WITH THE ARM-STAND(OPTION) Turn off the monitor and pull out the power cable. Place a cushion or a soft cloth on the floor and put the product on it with the front of the monitor facing the floor.
TROUBLESHOOTING TROUBLESHOOTING Symptom Symptom Check Check Picture is jitterd. Adjust Clock to set the screen position and adjust No sound. Check the audio cable are correctly connected to the Clock fine until a noise isn’t displayed. computer. No picture. Check if power switch and computer power switch Adjust the volume after checking the sound is muted.