HID312, HID525, HID540
Service Manual
Ice level controls
Clean if the controller indicates bin full and there
is no ice between the sensors.
1. Remove upper front and top panels, disconnecting
buttons from harness on button activated
dispensing models .
2. Shut machine off.
3. Disconnect ice level controls at connector.
Cover
Sensor
4. Remove 3 screws and ice storage bin cover.
5. Pull each sensor grommet clip up and off.
6. Push grommets out of bin top.
7. Pull each sensor out of its rubber grommet. Pull
on the part closest to the grommet, not the wire.
8. Wipe the sensor lenses clean with a soft, clean
cloth. Caution - do not scratch the lens. If there
is mineral scale on the lens, ice machine scale
remover will be needed to wipe them clean.
9. Return each sensor to a grommet, push it in until it
snaps into place.
10. Reverse the rest of the steps to reassemble.
Clip
Grommet
October 2020
Page 19