Table of Contents
Advertisement
Warnings and Safety Precautions
FCC Regulations state that any unauthorized changes or modifications to this equipment not express-
ly approved by the manufacturer could void the user's authority to operate this equipment.
CAUTION: TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT REMOVE COVER.
DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO DO NOT USE THIS UNIT'S POLAR-
IZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS, UNLESS THE
PRONGS CAN BE FULLY INSERTED. REFRAIN FROM OPENING THE CABINET AS THERE ARE
HIGH-VOLTAGE COMPONENTS INSIDE. NO USER-SERVICEABLE PARTS EXCEPT LAMP UNIT.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
High brightness light source. Do not stare into the beam of light, or view directly. Be especially careful
that children do not stare directly into the beam of light.
The cooling fan in this projector continues to run for about 90 seconds after the projector is turned off.
During normal operation, when turning the power off always use the power (OFF) button on the pro-
jector or on the remote control. Ensure the cooling fan has stopped before disconnecting the power
cord. The power outlet socket should be installed as near to the equipment as possible, and should
be easily accessible.
DURING NORMAL OPERATION, NEVER TURN THE PROJECTOR OFF BY DISCONNECTING
THE POWER CORD. FAILURE TO OBSERVE THIS WILL RESULT IN PREMATURE LAMP
FAILURE.
This projector utilizes tin-lead solder, high intensity discharge lamp (HID lamp) containing a small
amount of mercury. Disposal of these materials may be regulated due to environmental considera-
tions. For disposal or recycling information, please contact your local authorities or, if you are located
in the United States of America, the Electronic Industries Alliance: www.eiae.org
This equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the operation manual, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING
WARNING
WARNING
PRODUCT DISPOSAL
INFORMATION
4
.
Advertisement
Table of Contents
