Table of Contents
Advertisement
Creating Virtual Disks
This topic describes the procedure for creating virtual disks by using the Marvell BIOS
setup utility.
1.
In the Topology pane, scroll to [HBA 0: Marvell 0] and press Enter. A menu pops-up
as shown below. Select "Configuration Wizard" and press Enter to begin creating
the virtual disk.
Marvell BIOS Setup (c) xxxx Marvell Technology Group Ltd.
Topology
HBA 0: Marvell 0
Virtual Disks
Free physical Disks
PD 0: ST3750330MS
PD 8: ST3750330MS
Help
Select free disks to create array and continue to create virtual disk on
this array.
ENTER: Operation
2.
Press Space to select the disk, use the arrow keys to scroll the list of free disks.
After select the required disks as shown below, press Enter to continue.
Marvell BIOS Setup (c) xxxx Marvell Technology Group Ltd.
Configure -> Select free disks
HBA 0: Marvell 0
Virtual Disks
Free physical Disks
*
PD 0: ST3750330MS
*
PD 8: ST3750330MS
Help
Select free disks to create array and continue to create virtual disk on
this array.
ENTER: Operation
Information
Vendor ID
[Configuration Wizard]
Device ID
[Int13: Enable]
Revision ID
BIOS Version
Firmware Version
PCIe Speed Rate
Configure SATA as
F10: Exit/ Save
ESC: Return
Port ID
PD ID
Type
Status
Size
Feature Support
Current Speed
Model
Serial
FW Version
F10: Exit/ Save
ESC: Return
:
1848
:
91xx
:
81
:
1.0.0.1008
:
2.1.0.1316
:
5.0Gbps
:
AHCI Mode
:
1
:
8
:
SATA PD
:
Unconfigured
:
953869MB
:
NCQ 6G 48Bits
:
6G
:
ST37503330MS
:
ST-XXXXXX
:
05.01D05
MS-7688
MS-7688
C-3
Advertisement
Table of Contents
