Table of Contents
Advertisement
Marvell RAID
Marvell RAID
RAID Configuration
During bootup, a screen similar to the one below will appear for about few seconds.
Press <Ctrl>+<M> to enter Marvell BIOS setup utility.
Press <Ctrl>+<M> to enter BIOS Setup or <Space> to continue
Important
Be sure to enable the RAID function for SATA device in mainboard BIOS before config-
uring the Marvell BIOS setup utility.
The RAID setup utility menu screen will appear. The Main Menu shows as below.
Topology
HBA 0: Marvell 0
Virtual Disks
Free physical Disks
PD 0: ST3750330MS
PD 8: ST3750330MS
Help
Marvell RAID on chip controller.
ENTER: Operation
■
Topology - this pane used a tree view to list and show the relationships between
the various physical/ virtual devices attached to system.
■
Information - this pane is populated based on the selection in the Topology pane.
■
Help - this pane is used to display important information relevant to the selection.
It may contain short descriptions on selections, messages on setting list items,
default values for settings, among others.
C-2
Marvell BIOS Setup (c) xxxx Marvell Technology Group Ltd.
Information
Vendor ID
Device ID
Revision ID
BIOS Version
Firmware Version
PCIe Speed Rate
Configure SATA as
F10: Exit/ Save
ESC: Return
:
1848
:
91xx
:
81
:
1.0.0.1008
:
2.1.0.1316
:
5.0Gbps
:
AHCI Mode
Advertisement
Table of Contents
