Searching An Input Signal; Selecting An Aspect Ratio - Dukane ImagePro 8792H General User Manual

Searching an input signal

1.
Press SEARCH button on the remote control.
The projector will start to check its input ports as below in
order to find any input signals.
When an input is found, the projector will stop searching
and display the image. If no signal is found, the projector will
return to the state selected before the operation.
COMPUTER IN  HDMI
VIDEO
● While ON is selected for AUTO SEARCH item in OPTION menu (46), the
projector will keep checking the ports in above order repeatedly till an input
signal is detected.

Selecting an aspect ratio

1.
Press ASPECT button on the remote control.
Each time you press the button, the projector switches the
mode for aspect ratio in turn.
 For a computer signal
NORMAL  4:3  16:9  16:10
 For an HDMI signal
NORMAL  4:3  16:9  16:10  14:9
 For a video signal, s-video signal or component video
signal
4:3  16:9  14:9
 For no signal
4:3 (fixed)
● ASPECT button does not work when no proper signal is inputted.
● NORMAL mode keeps the original aspect ratio setting.
S-VIDEO
Operating
SEARCH button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
AUTO
ASPECT SEARCH BLANK
PAGE VOLUME
MAGNIFY FREEZE
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON MUTE
1 2
MENU
POSITION
ENTER
RESET
ESC
ASPECT button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
DOWN
OFF
KEYSTONE
MY BUTTON MUTE
1 2
POSITION MENU
ENTER
ESC RESET
17