Table of Contents
Advertisement
This is the Internet version of the user's guide. © Print only for private use.
To set up a Dial-Up entry for CSD or HSCSD
1. On the PC, open the Control Panel.
2. Choose to install a new modem.
3. Choose your P910i as the modem.
4. Select the port where the P910i is connected.
5. Confirm the selection. A new DUN connection has been
created.
Connecting
To connect using a DUN entry created by the wizard
1. If you are connecting by cable, set your P910i to
connection mode, see 'Cable' on page 152.
2. Use any conventional method to make a connection:
– Click the Desktop shortcut created by the wizard.
– Select the entry from within the system DUN folder.
– Run an application that has built-in support for using
DUN entries (for example a browser or email client).
174
Getting started with Internet and Messages
GPRS - connection information
Icons on the status bar let you overview the information on data
connection calls.
A combined signal strength and GPRS signal icon provides
information on the GPRS service status. The GPRS connection
status appears above the signal strength icon. There are three
states for the icon, unavailable
attached
The HSCSD/CSD
a data connection. Where GPRS is suspended, for example, the
GPRS suspended state is indicated by a combined icon
cable
There are three states for the GPRS icon: Active
Modem
active transferring data (alternates between
and suspended
activates the GPRS active icon for 5 seconds.
Connection information
When you select the data connection icon, during an active data
connection, a menu appears with the choices
Disconnect
• Select
• Select
, available
.
and GPRS
icons are displayed during
. Any data transfer either received or sent
.
to view information on the connection.
Information
to end the connection.
Disconnect
and
.
,
and
)
and
Information
Advertisement
Table of Contents
