Rowenta ADVANCER Manual page 11

7 • Steam ironing
You can steam iron from temperature setting •• up. The steam
quantity can be adjusted between Smooth Steam
(continuous low pressure steam) up to High Pressure steam
We recommend setting to High Pressure steam only when the iron
is at temperature setting •••.
8 • High Pressure Steam
Your iron is fitted with the new High Pressure Steam system
(fig.13). This technology generates higher steam pressure to enable
the steam to penetrate much faster and further into the fabric.
This way you get excellent results from your ironing.
The steam is emitted in frequent bursts rather than continuously.
The pressure generated may cause a slight noise. This is not a
technical fault!
9 • Shot of Steam
IMPORTANT Leave an interval of 4 seconds between each
shot and wait until the flow of steam is finished before
standing the iron on its heel.
Press the shot of steam button
steam and remove stubborn creases (fig.14).
10 • Vertical shot of steam
(from temperature setting •• upwards)
TIP Hold the iron 10 to 20 centimetres away from the garment
to avoid burning delicate fabrics.
Hold the iron to the vertical and press the shot of steam button
(fig.15) to remove creases from suits, jackets, skirts, hanging
curtains etc.
IMPORTANT Never direct the steam at persons or animals!
11 • Spray
Press the spray button
12 • Anti-Drip system*
This prevents water escaping from the soleplate when the
temperature is too low.
* depending on model
(from temperature setting •• upwards)
to generate a powerful jet of
to dampen stubborn creases (fig.16).
5
(fig.12)
.