Troubleshooting - Amana ACR4303MFB2 User Instructions

First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call,
refer to the warranty page in this manual, or visit http://amana.custhelp.com.
Contact us by mail with any questions or concerns at the address below:
Amana Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
Operation
Problem
Nothing will operate
Cooktop will not operate
Excessive heat around
cookware on cooktop
Cooktop cooking results not
what expected
Cooktop element cycles on
and off on High setting
Oven will not operate
Oven temperature too high or
too low
Oven indicator lights flash
Display shows messages
Self-Cleaning cycle will not
operate
14

TROUBLESHOOTING

Possible Causes
Power supply cord is unplugged.
Household fuse is blown or a
circuit breaker is tripped.
The control displays an F9 or
F9 E0 error code.
The control knob is set incorrectly.
On ceramic glass models, the
oven control lockout is set.
A Self-Cleaning cycle has been
selected.
Cookware that is not the proper
size.
Control knob set to incorrect
heat level.
Range is not level.
Element cycling due to a
temperature limiter
Control lock is ON.
Control is in Demo mode.
Electronic oven control set
incorrectly.
Oven temperature needs
adjustment.
Power to range is turned on or
restored.
Power failure (display shows
flashing time).
Error code (display shows letter
followed by number).
Start needs to be pressed so a
cycle can begin.
The oven door is not closed.
The Self-Cleaning function has not
been entered correctly.
Solutions
Plug into a grounded outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
The electrical outlet in the home may be miswired. Contact a
qualified electrician to verify the electrical supply.
Push in knob before turning to a setting.
See the "Control Lock" keypad feature in the "Feature Guide"
section.
On some ceramic glass models, the cooktop will not operate
during a Self-Cleaning cycle.
Use cookware about the same size as the surface cooking
area, element, or surface burner. Cookware should not extend
more than 1/2" (1.3 cm) outside the cooking area.
See the "Cooktop Use" section.
Level the range. See the Installation Instructions.
This is normal operation. The element may cycle on and off to
keep the cooktop from overheating.
Press and hold CONTROL LOCK for 3 seconds to unlock.
Demo mode will deactivate all oven elements. See "Demo
Mode" in the "Electronic Oven Controls" section.
See the "Electronic Oven Controls" section.
See the "Oven Temperature Control" in the "Electronic Oven
Controls" section.
See "Control Display" in the "Electronic Oven Controls"
section. If the indicator light(s) keep(s) flashing, call for service.
See the "Warranty" section for contact information.
Clear the display. On some models, reset the clock, if needed.
See "Clock" keypad feature in the "Feature Guide" section.
Depending on your model, press OFF/CANCEL to clear the
display. See "Control Display" in the "Electronic Oven Controls"
section. If it reappears, call for service. See the "Warranty"
section for contact information.
See the "Start" keypad feature in the "Feature Guide" section.
Make sure the oven door is fully closed.
See the "Self-Cleaning Cycle" section.