Samsung FX710BGS User Manual page 75

Free-standing gas range
Hide thumbs Also See for FX710BGS:
Table of Contents

Advertisement

Available languages

Available languages

PROBLEM
Steam or smoke coming
from under the control
panel.
Burning or oily odor
emitting from the vent.
Strong odor.
oven racks are difficult
to slide.
Fan noise.
convection fan is not
working.
Warming drawer
will not work (model
FX710BGS).
excessive condensation
in the warming drawer
(model FX710BGS).
Warming drawer or
storage drawer does not
slide smoothly or drags.
(IB)FX710BGS,FX510BGS,NX583G0VB_DG68-00399A-06_EN.indd 75
POSSIBLE CAUSE
This is normal.
This is normal for a new oven
and will disappear within 1/2
hour of the first bake cycle.
This is temporary.
This is normal.
The controls are not set properly. Reset the controls as described
The Self-Clean or Sabbath
function is being used.
The oven controls have been
locked.
There is a blown fuse or tripped
circuit breaker.
The temperature setting is too
high.
The foods being warmed are not
covered with a lid or aluminum foil.
You are trying to warm liquids.
The drawer is not properly
aligned with the full-extension
roller guide rails or nylon drawer
guides.
The contents in the drawer are
too heavy.
SOLUTION
The oven vent is located there.
More steam is visible when using
the convection functions or
when baking or roasting multiple
items at the same time.
To speed the process, set a self-
cleaning cycle for a minimum of
3 hours. (See pages 68 and 69.)
The insulation around the inside
of the oven emits an odor the
first few times the oven is used.
Apply a small amount of
vegetable oil to a paper towel
and wipe edges of the oven
racks with the paper towel.
Racks become dull and hard to
slide when they are left in the
oven during a self-clean cycle.
The convection fan runs until the
function is over or the door is
opened.
The fan starts automatically
when the oven meets the
preheat temperature.
on page 52 and 53.
The warming drawer will not
operate during either of these
operations. Try again after the
function is completed or cancelled.
Unlock the controls and try
again.
Replace blown fuse or reset
tripped circuit breaker.
See page 53.
Cover foods with a lid or
aluminum foil.
Liquid should not be warmed in
the drawer. Remove liquids.
Remove and replace the drawer.
(See page 64.)
Reduce the weight and/or
redistribute the contents in the
drawer.
troubleshooting _75
2013-05-07
4:19:57

Advertisement

Table of Contents
loading

Table of Contents