Gigabyte GA-8IE533 User Manual page 21

5)Floppy Connector]
6)IDE1 / IDE2 Connector
(Primary/Secondary]
7)RAM_LED
8)PWR_LED
1
Ø Important Notice:
The red stripe of the ribbon cable must be the
same side with the Pin1.
1
Ø Important Notice:
Please connect first harddisk to IDE1
and connect CD_ROM to IDE2.
IDE2
The red stripe of the ribbon cable must be the
1
same side with the Pin1.
1
IDE1
Ø Do not remove memory modules while
DIMM LED is on. It might cause short or
other unexpected damages due to the
2.5V stand by voltage. Remove memory
modules only when AC Power cord is
disconnected.
Ø PWR_LED is connect with the system power
indicator to indicate whether the system is
on/off. It will blink when the system enters
suspend mode.
- 17 - Hardware Installation Process