Operation - DeWalt DCF680N2 Instruction Manual

Torque Adjustment Collar (Fig. 3)
The torque adjustment collar (I) is marked with numbers and a 'MAX'
symbol. The higher the number on the collar, the higher the torque. To
lock the clutch for fastening operations, move to the 'MAX' position.
Failure to do this will allow the clutch to slip while attempting to fasten.
Quick Release Chuck (Fig. 1)
NOTE: The chuck accepts 1/4" (6.4 mm) hex accessories only.
To install a bit, insert the bit into the chuck until the clip locks it in place.
To remove a bit, pull the chuck (H) forward. Remove the bit and
release the chuck.

OPERATION

WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 4)
NOTE: For best results, make sure your
battery pack is fully charged.
To install the battery pack (G) into the tool
handle, align the battery pack with the
recess in the tool's handle and slide it into
the handle until the battery pack is firmly
seated in the tool and ensure that it does
not disengage.
To remove the battery pack from the tool,
press the release button (F) and firmly pull
the battery pack out of the tool handle.
Insert it into the charger as described in the
charger section of this manual.
BATTERY FUEL GAUGE (FIG. 5)
The D
has a fuel gauge which consists of
three green LED lights that indicate
the level of charge remaining in the
battery pack.
To actuate the fuel gauge, press and
hold the motion control activation
trigger (A). A combination of the
three green LED lights will illuminate
designating the level of charge left.
When the level of charge in the battery is below the usable limit, the
fuel gauge will not illuminate and the battery will need to be recharged.
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate tool functionality and is subject to
variation based on product components, temperature and end-user
application.
For more information regarding the battery fuel gauge, please call
1-800-4-D
FIG. 4
com.
To Operate
Your screwdriver uses gyroscopic technology to sense your hand
motion. To operate, press in the motion control activation trigger
and turn your hand in the direction that you want the screwdriver to
operate.
G
SETTING INITIAL STARTING POINT
1. Grasp the screwdriver as shown in Figure 6.
2. Press and hold in the motion control activation trigger.
F
3. When the LED illuminates the tool is ready for use.
10
WALT cordless screwdriver
E
WALT (1-800-433-9258) or visit our website www.dewalt.
E
FIG. 5
A