Fujitsu F2 MC-16L Operation Manual page 12

2.4 Connecting a Probe to the Adapter Board
Connect a probe to the adapter board.
Note : Two pairs (A1/A2 and B1/B2) of connectors are mounted on the adapter board.
Please use only one pair of probe connector when you debug it, and do not use both pairs
simultaneously.
■ Connecting a probe to the Adapter Board (using a probe cable)
Connect a probe cable to probe connector A1/A2 of the adapter board, as shown in Figure 7.
PROBE CN A1
PROBE CN B1
Adapter board
Figure 7 Connecting a probe to the Adapter Board (using a probe cable)
■ Connecting a probe to the Adapter Board (using a flat cable)
Connect a flat cable to probe connector B1/B2 of the adapter board, as shown in Figure 8.
Adapter board
PROBE CN A1
PROBE CN B1
To connect a flat cable, push in the connector until the eject locks on both sides of the cable connector
are locked.
To disconnect a flat cable, pinch the eject locks on both sides of the cable connector to unlock the flat
cable, and pull out the connector.
Figure 8 Connecting a probe to the Adapter Board (using a flat cable)
8
PROBE CN A2
PROBE CN B2
PROBE CN A2
PROBE CN B2
Eject locks
Probe cable
Flat cable