Fujitsu F2 MC-16L Operation Manual page 11

■ Connecting to the user system (using flat cables and a probe header)
Connect the corresponding probe header of the mass-production MCU package to be used to the con-
nector of the user system, as shown in Figure 5.
See the probe cable operation manual of the relevant product for information on how to connect the
connector of the probe header.
To connect a flat cable, push in the connector until the eject locks on both sides of the cable connector
are locked.
To disconnect a flat cable, pinch the eject locks on both sides of the cable connector to unlock the flat
cable, and pull out the connector.
Figure 5 Connecting to the user system (using flat cables and a probe header)
■ Connecting to the user system (using flat cables)
If the same connectors as probe connector B1/B2 of the adapter board are mounted on the user sys-
tem, the adapter board can be connected to the user system via a flat cable.
See "4. USER I/F SPECIFICATIONS", for details on the I/F specifications of probe connector B1/
B2.
Connect a flat cable to probe connector B1/B2 of the user system, as shown in Figure 6.
To connect a flat cable, push in the connector until the eject locks on both sides of the cable connector
are locked.
To disconnect a flat cable, pinch the eject locks on both sides of the cable connector to unlock the flat
cable, and pull out the connector.
Flat cable
Flat cable
Figure 6 Connecting to the user system (using flat cables)
PROBE CN B1 PROBE CN B2
Probe header
PROBE CN B1 PROBE CN B2
User system
Eject locks
User system
Eject locks
7