F) F_PANEL (2x7 pins jumper)
HD (IDE Hard Disk Active LED) Pin 1: LED anode(+)
SPK (Speaker Connector)
RST (Reset Switch)
PD+/PD_G/PD_Y(Power LED)
PW (Soft Power Connector)
Please connect the power LED, PC speaker, reset switch and power switch etc of your chassis
front panel to the front panel jumper according to the pin assignment above.
2
1
Pin 2: LED cathode(-)
Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
Open: Normal Operation
Close: Reset Hardware System
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 3: LED cathode(-)
Open: Normal Operation
Close: Power On/Off
14
13
2 3
Hardware Installation Process