Hitachi CPX2(M1-20ML) Service Manual page 17

All manuals and user guides at all-guides.com
A
NO
Is PC LAN settings same as
following ?
CH:1, SSID:default, ENCRYPTION:off, MODE:
YES
ADHOC, SPEED:AUTO
NOTE: Method of changing the PC LAN setting
depends on your PC. Please read your PC manual.
Is wired
LAN at PC's
NO
network setting disabled?
(Refer Fig.4-1 to 4-2)
YES
NO
Can you connect via
wired LAN ?
Change PC's IP address setting to "192.168.1.N"
(N:1 to 9 or 11 to 254) And check wired LAN
YES
connection when wireless LAN is disabled.
Are there any other
YES
PC or something using
wireless LAN?
NO
Is the
wireless LAN
NO
device installed correctly on
your PC?
Point to be checked : If you set PC's IP address setting to
YES
"192.168.1.50", input in MS-DOS prompt to "ipconfig" and
response the same IP "192.168.1.50". (Refer Fig.6)
PWB assembly MAIN
CPX2(M1-20WL)
Change PC LAN settings.
Disable wired LAN, and confirm
only wireless LAN is enabled.
PWB assembly MAIN
Change the WIRELESS NETWORK
and your PC's wireless channel
setting differ to other PC or something,
And change SSID except for "wireless".
(When you change SSID, we recommend
to use wired LAN for running "Setting Utility")
(Refer Fig.5)
How to change into wired LAN.
(1) Use MIU SETUP - NETWORK MODE
(2) Remove SD WLAN card, turn off the
power switch, and then pull out the power cord.
Refer your wireless LAN device's
installation manual, and install
wireless LAN device's driver again.
17