Stylus Input Not Working; The Tablet Pc Does Not Start After Switch On; The Tablet Pc Stops Working - Fujitsu STYLISTIC R727 Operating Manual

Stylus input not working

Cause
Incorrect driver installed.
Stylus is in sleep mode.
Stylus battery is completely discharged.

The Tablet PC does not start after switch on

TabletPC
Cause
The battery is dead.
The AC adapter is not connected properly.

The Tablet PC stops working

Ending TabletPC
Cause
The Tablet PC is in energy saving mode.
An application program has caused the
malfunction.
The battery is dead.
Fujitsu
Troubleshooting
► If your device is one which can only be
operated using the stylus, install the driver
for the standard model.
or
► If your device is one which can be
operated using the stylus and by finger,
install the driver for the "Dual Digitizer"
model.
► Press the upper stylus button to wake the
stylus from sleep mode.
► Change the stylus battery as described in
chapters "Removing the stylus battery",
Page 34 and "Installing the stylus battery",
Page 34.
Troubleshooting
► Charge the battery.
or
► Connect the AC adapter to the Tablet
PC.
► Check whether the AC adapter is properly
connected to the Tablet PC.
► Switch the Tablet PC on.
Troubleshooting
► End energy saving mode.
► Close the application program or restart
the Tablet PC (by restarting the operating
system or switching the device off and back
on again).
► Charge the battery.
or
► Connect the AC adapter to the Tablet
PC.
Troubleshooting and tips
75