Gigabyte 7NF-RZ-C User Manual page 15

8) F_PANEL (Front Panel Connector)
Please connect the power LED, PC speaker, reset switch and power switch etc. of your chassis front
panel to the F_PANEL connector according to the pin assignment below.
HD (IDE Hard Disk Active LED)
SPK (Speaker Connector)
RES (Reset Switch)
PW (Power Switch)
MSG (Message LED/ Power/ Sleep LED)
NC
9) F_AUDIO (Front Audio Connector)
If you want to use Front Audio connector, you must remove 5-6, 9-10 Jumper.
In order to utilize the front audio header, your chassis must have front audio connector. Also please
make sure the pin assigment on the cable is the same as the pin assigment on the MB header. To find
out if the chassis you are buying support front audio connector, please contact your dealer. Please note,
you can have the alternative of using front audio connector or of using rear audio connector to play
sound.
Message LED/Power/
Sleep LED
Power Switch
2
1
IDE Hard Disk Reset Switch
Active LED
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
Open: Normal Operation
Close: Reset Hardware System
Open: Normal Operation
Close: Power On/Off
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
NC
Pin No.
1
10 9
2
3
4
5
2 1
6
7
8
9
10
- 15 -
Speaker Connector
20
19
Definition
MIC
GND
MIC_BIAS
Power
Front Audio (R)
Rear Audio (R)
Reserved
No Pin
Front Audio (L)
Rear Audio (L)
Hardware Installation Process