Advertisement
(3) Configuring RAID set in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step and proceed to Section 4 if
you do not want to create RAID.
Step 1:
After the POST memory test begins and before the operating system boot begins, look for a message
which says "Press <Ctrl>+<S> to enter Setup Menu or <ESC> to skip waiting" (Figure
4). Hit CTRL+S to enter the RAID BIOS setup utility. If you cannot enter the RAID BIOS correctly, assure
that your SATA drives are properly installed.
Figure 4
Step 2
Press CTRL+S. The SiS RAID BIOS Setting Utility - Disk Status window appears (refer to Figure
5). To create RAID, press R to enter the RAID Setup utility.
Figure 5
- 5 -
SATA Hard Drive Configurations (SiS 964)
Advertisement
