Table of Contents
Advertisement
Remote Control
a Turning on the power/Going to standby
(page 7)
? (On) button
1 (Standby) button
b Selecting an input signal (page 13)
A - E buttons: Selects the following input connector.
Button
Input connector
A
DisplayPort 1
B
DisplayPort 2
C
DisplayPort 3
D
DisplayPort 4
E
DisplayPort 1/2
F button: Not available.
INPUT button: Press to change the input connector in
order from A to E.
c Operating a menu (page 16)
ENTER/M/m/</, buttons
MENU button
RESET button
d Adjusting the lens
FOCUS button: Adjusts the focus.
ZOOM button: Adjusts the screen size with the
zooming magnification.
SHIFT button: Adjusts the projection position of the
image.
PRECISE ADJ button: Not available.
e Adjusting the image
BRIGHTNESS button: Adjusts the brightness
(page 19).
LIGHT OUTPUT button: Adjusts the laser output of
the light source (page 19).
CONTRAST button: Adjusts the contrast (page 19).
f Using various functions while projecting
BLANK button: Cuts off the image. Press again to
restore the image.
POSITION button: Stores and recalls the lens settings
(page 14).
MOTIONFLOW button: Reproduces fast-moving
images smoothly (page 19).
CONTRAST ENHANCER button: Corrects the
image automatically to optimize the contrast
according to a scene (page 19).
REALITY CREATION button: Adjusts the detail and
noise processing of images (page 18).
g ID MODE switch
Sets the ID mode of the remote control. If a different
ID number is assigned to each projector when
multiple projectors are used, you can operate only the
projector with the same ID mode as that of the remote
control (page 29).
h Infrared transmitter
Transmits the infrared light. Direct toward the
projector you want to operate.
i IR output connector
Connects to the IR IN connector on the projector with
a connecting cable (stereo mini plug (not supplied))
when using the remote control as a wired one. You do
not need to install batteries in the remote control.
5
Advertisement
Table of Contents
