Table of Contents
Advertisement
Section 3 - Configuration
You can configure your specific wireless network settings in this section. Click Save Settings to apply them.
Wi-Fi Protected
To implement WPS, tick the Enable checkbox. Click either
Generate New PIN or Reset PIN to Default, then configure
Setup:
the Wi-Fi settings below. Click Add Wireless Device with
WPS to connect a WPS-enabled device.
Select between Wireless Router, Access Point, WDS Only,
Wireless Mode:
WDS +AP, WDS +AP +Router modes.
Enable Wireless:
Check the box to enable the wireless function. If you do
not want to use wireless, uncheck the box to disable all the
wireless functions.
Wireless Network
Service Set Identifier (SSID) is the name of your wireless
Name:
network. Create a name using up to 32 characters. The SSID
is case-sensitive.
Enable Auto
This setting can be selected to allow the DIR-605L to choose
Channel Selection:
the channel with the least amount of interference.
Wireless Channel:
Indicates the channel setting for the DIR-605L. By default
the channel is set to 6. The channel can be changed to fit
the channel setting for an existing wireless network or to
customize the wireless network.
Enable Hidden
Check this option if you would not like the SSID of your
Wireless:
wireless network to be broadcasted by the DIR-605L. If this
option is checked, the SSID of the DIR-605L will not be seen
by Site Survey utilities so your wireless clients will have to
know the SSID of your DIR-605L in order to connect to it.
D-Link DIR-605L User Manual
Wireless Connection
22
Advertisement
Table of Contents
