TRANSMITTER may be made by Ericsson Inc., at any time and without notice. Such changes will be incorporated into new editions Frequency Range of this manual. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or...
Page 3
LBI-39015 SPECIFICATIONS* - Cont. Continued Audio Sensitivity 110 mV RMS (typical) STANDARD METHODS PROCEDURES Spurious and Harmonics Less than -16 dBm Mechanical Shock 516.2/Proc 1 516.3/Proc 1-6 516.4/Proc 1-6 Audio Distortion 5% maximum Humidity 507.1 507.2 507.3 ±5 kHz (Maximum) Modulation Limiting Salt Fog 509.1/Proc 1...
LBI-39015 DESCRIPTION Synthesizer sizer and sends and receives data to/from another microproc- PC PROGRAMMED OPTIONS essor on the Display Board for the alphanumeric LED dis- play. The synthesizer circuit generates all transmit and receive The VHF MDX™ Mobile Radio is a synthesized, wide Carrier Control Timer (CCT) RF frequencies.
RECEIVER SCAN RATE NOTE: ceived. The option connects to Pin 13 of cable option Primary codes in bold are unique Ericsson codes. PMCD7Z (19C851585P14) and is enabled through the front The scan rate for the radio will vary depending upon the panel switch.
Page 6
LBI-39015 Scan operation will be determined by the following condi- Press the programmed flex key, mapped to scan DELETE SCAN CHANNEL (S, P1, P2) DISPLAY tions: add/delete, to add the channel to the scan list. The S indicator will be shown in the display to indicate that Confirm that the radio is on.
LBI-39015 MONITOR (CLR) SWITCH OPERATION IN grammable from 0.3 to 5 seconds on 0.1 seconds steps. If no other channel activity occurs during this SCAN time, scanning will then resume. The priority chan- nels are still being sampled during the hang time. The CLR switch does not operate while scanning inac- tive channels.
The MDX radio can be PC programmed with up to three Carrier on P2 If the Public Address Option is present, the radio may be separate tables of tones. Either the Ericsson GE Type 99 for- CONDITION 1: P1 and P2 have Channel Guard Programmed Stop on P2, scan P1 used as public address amplifier.
DATAFILE BULLETIN DF-5000-3A. <-1.0 SEC MIN-> <----NONE----> <--3 SEC MIN--> 637.5 Hz Tone D is the diagonal tone used (Ericsson GE tone sys- 652.5 Hz TONE C TONE B tems only) when the first and second tone frequencies are the 607.5 Hz...
Page 10
LBI-39015 Table 5 - Motorola Type Code Numbers GROUP CALL (Quick-Call Format) Table 6 - Motorola Tone Frequencies and Groups In Group Call application, the Tone Group is determined by table 7, while the frequency is determined by Table 6. Refer to First Digit of Group From Which Group From Which...