LBI-39014 LBI-39014 Continued Continued SPECIFICATIONS* ENVIRONMENTAL RECEIVER STANDARD METHODS PROCEDURES Frequency Range Low Split Radio 403 to 440 MHz Mechanical Shock 516.2/Proc 1 516.3/Proc 1-6 516.4/Proc 1-6 Mid Split Radio 440 to 470 MHz Humidity 507.1 507.2 507.3 High Split Radio...
Display Board for the alphanumeric LED dis- play. The synthesizer circuit generates all transmit and receive The Ericsson GE UHF MDX™ Mobile Radio is a synthe- Carrier Control Timer (CCT) RF frequencies. The synthesizer frequency is controlled by the sized, wide band radio that uses integrated circuits and micro- microprocessor located on the Audio/Logic Board.
LBI-39014 LBI-39014 In the conventional mode of operation, the user selects a Table 2 - Digital Channel Guard Codes CABLE OPTION PMCD7ZE channel and communicates on that channel in the conventional mode. A system refers to a set of channels and a channel is a Cable Option PMCD7Z (19D851585P14) is used to bring PRIM.
Page 6
LBI-39014 LBI-39014 Scan operation will be determined by the following condi- Press the programmed flex key mapped to scan DELETE SCAN CHANNEL (S, P1, P2) DISPLAY tions: add/delete to add the channel to the scan list. The S indicator will be shown in the display to indicate that Confirm that the radio is on.
Page 7
LBI-39014 LBI-39014 time is normally 2 seconds in length and PC pro- MONITOR (CLR) SWITCH OPERATION IN grammable from 0.3 to 5 seconds on 0.1 seconds SCAN steps. If no other channel activity occurs during this time, scanning will then resume. The priority chan- The CLR switch does not operate while scanning inac- nels are still being sampled during the hang time.
LBI-39014 LBI-39014 Priority 1 Channel Programming: than or equal to four, then all non-priority channels will be Carrier on P2 detected/wrong Channel Guard CONDITION 3: P2 has Channel Guard, P1 does not scanned between each P1, P2 scan. P1-P2-P1-P1-P1-P1-P1-P1-P1-P1-P1-P2-P1... • Method 1 - Front programmable (default)
787.5 Hz When a T99 call is received, the entire display will alter- 823.5 Hz Tone D is the diagonal tone used (Ericsson GE tone sys- nate between "T99" and the normal channel display and an 877.5 Hz In the Ericsson GE tone format, the first tone may be tems only) when the first and second tone frequencies are the alert tone will sound.
Page 10
LBI-39014 LBI-39014 In the Motorola tone format, the first tone may be one to Table 5 - Motorola Type Coder Numbers Table 6 - Motorola Tone Frequencies and Groups three tones: A for individual call, B for Quick-Call and C for Group Call.