Connecting Other Components; Connecting A Powered Subwoofer; Connecting An Audio Playback Device - Onkyo CR-245BT Instruction Manual

E39_CS-355_En_120614.book 15 ページ ２０１２年６月１４日 木曜日 午後１時４８分
Connecting the Antennas
■ Using a TV / FM Antenna Splitter
It's best not to use the same antenna for both FM and TV
reception, as this can cause interference problems.
If circumstances demand it, use a TV / FM antenna
splitter, as shown.

Connecting Other Components

Analog audio
cable (RCA)
e.g.,
cassette tape deck
About Connections
• Before making any connections, read the manuals
supplied with your other components.
• Don't connect the power cord until you've completed
and double-checked all connections.
Push plugs in all the way to make
good connections (loose connections
can cause noise or malfunctions).
Note:
• Do not put anything on top of the CD receiver, as it
may interfere with proper ventilation.
—Continued
CD receiver
Powered
subwoofer

Connecting a Powered Subwoofer

Using a suitable cable, connect the CD receiver's
AUDIO OUT: SUBWOOFER to the input on your
powered subwoofer.
If your subwoofer is unpowered and you're using an
external amplifier, connect the AUDIO OUT:
Right!
SUBWOOFER to the amp's input.
Note:
• Do not connect or disconnect the power cord while the
subwoofer is powered-on. Doing so may damage the
Wrong!
subwoofer. You must power-off the subwoofer before
connecting or disconnecting the power cord.
Connecting an Audio Playback
Device
Using a suitable cable, connect the CD receiver's LINE
IN jacks to the OUTPUT (PLAY) jacks of your cassette
tape deck, TV, or other audio playback device.
TV / FM antenna
splitter
To CD receiver To TV (or VCR)
To wall outlet
(Connector type varies from
country to country.)
15