Panasonic PT-VX615N Operating Instructions Manual page 105

Setting [CUT IN]
Set this to decide whether to allow image interrupted by other users or by the simultaneous image transfer
function of "Multi Monitoring & Control Software" while using Panasonic's image transfer application software to
project the device screen.
1) Press as to select [Panasonic APPLICATION].
2) Press the <ENTER> button.
f The [Panasonic APPLICATION] screen is displayed.
3) Press as to select [CUT IN].
4) Press qw to switch the item.
f The item will switch each time you press the button.
[ON]
[OFF]
Note
f You cannot set [CUT IN] when [MODERATOR MODE] is set to [ON].
f If you use "Multi Monitoring & Control Software" and "Wireless Manager ME6.4" at the same time on the same computer, simultaneous
image distribution function of "Multi Monitoring & Control Software" may not work properly. To use them at the same time, use each of the
software on separate computers.
Setting [PASSWORD]
When trying to connect to the projector with Panasonic's image transfer application software, you are required to
enter the password of the device. By requiring the password entry, it is possible to prevent the image display cut-in
by an incorrect connection from external devices.
1) Press as to select [Panasonic APPLICATION].
2) Press the <ENTER> button.
f The [Panasonic APPLICATION] screen is displayed.
3) Press as to select [PASSWORD].
4) Press qw to switch the items.
f The item will switch each time you press the button.
[OFF]
[ON]
Note
f The factory default setting or the setting after executing the [NETWORK/USB] menu → [INITIALIZE] is set to [OFF]. To connect to the
projector using image transfer application software, it is recommended to set [PASSWORD] to [ON] after registering the password from the
[NETWORK/USB] menu → [Panasonic APPLICATION] → [PASSWORD CHANGE].
f When you use functions of "Multi Monitoring & Control Software" for simultaneous image distribution or deleting distributed images, images
cannot be distributed to the projector on which [PASSWORD] is set to [ON]. To use those image distribution functions, set it to [OFF].
Performing [PASSWORD CHANGE]
Register or change the password for connecting to the projector using Panasonic's image transfer application
software.
1) Press as to select [Panasonic APPLICATION].
2) Press the <ENTER> button.
f The [Panasonic APPLICATION] screen is displayed.
3) Press as to select [PASSWORD CHANGE].
4) Press the <ENTER> button.
f The [PASSWORD CHANGE] screen is displayed.
5) Press asqw to select characters and press the <ENTER> button to enter.
f You can enter up to eight ASCII characters.
Chapter 4 Settings - [NETWORK/USB] menu
Select to enable the image cut-in.
Select to disable the image cut-in.
Select to disable the password entry requirement.
Select to enable the password entry requirement.
ENGLISH - 105