Sanyo PLC-WXU700 Owner's Manual page 59

Setting
Lamp control
This function allows you to change brightness of the screen.
Auto ........... The brightness according to the input signal
High ........... Brighter than the Normal mode.
Normal . ...... Normal brightness
Eco ............ Lower brightness reduces the lamp power
Note:
Lamp mode cannot be changed for a while after turning
on the projector. Lamp needs some time to stabilize
after the power is turned on. Stored lamp mode will be
active after the lamp is stabilized.
Remote control
The eight different remote control codes (Code 1-Code 8)
are assigned to the projector; the factory-set, initial code
(Code 1) and the other seven codes (Code  to Code 8).
The same code should set on both the projector and the
remote control. For example, operating the projector in
Code 7, the remote control code also must be switched to
Code 7.
To change the code for the projector
Select a remote control code in this Setting Menu.
To change the code for the remote control:
While holding down the MENU button, press the IMAGE
button the number of times corresponding to the remote
control code for the projector. See "Remote Control Code"
on page 13.
Note:
• When different codes are set on the projector and on
the remote control, any operation cannot be made. In
that case, switch the code on the remote control to fit
the code on the projector.
• If the batteries are removed from the remote control for
a long period of time, the remote control code will
be reset.
58
(between High and Eco mode).
consumption and extends the lamp life.
Remote control