Troubleshooting - BenQ DH551C User Manual

26

Troubleshooting

Troubleshooting
Symptom
No picture is displayed.
Interference displayed on
the display or audible
noise is heard.
Color is abnormal.
Picture is distorted with
abnormal patterns
After-Images can still be
seen on the display after
the display is powered
off.
Possible Cause
1. The power cord is
disconnected.
2. The main power
switch on the back of
the display is not
switched on.
3. The selected input
has no connection.
4. The display is in
standby mode.
Caused by surrounding
electrical appliances or
fluorescent lights
The signal cable is not
connected properly.
1. The signal cable is
not connected prop-
erly.
2. The input signal is
beyond the
capabilities of the
display.
A still picture is displayed
for an excessive period
of time.
Remedy
1. Plug in the power cord.
2. Make sure the power switch
is switched on.
3. Connect a signal connection
to the display.
Move the display to another
location to see if the
interference is reduced.
Make sure that the signal cable is
attached firmly to the jack on
the display.
1. Make sure the signal cable is
attached firmly.
2. Check the video signal
source to see if it is beyond
the range of the display.
Please verify input
specifications.
Do not display a still image for
an excessive period of time
since this can cause a permanent
after-image remaining on the
display.