INSTALLATION OF INDOOR, OUTDOOR UNIT
12
Preparing work for Installation (ART COOL Type Only)
Open panel front
1
First, push the front panel backward and lift it up to remove the two screws.
2
The moment of lifting the both lower parts of panel front, you can hear sound this panel came
out, In this time panel front is separated
3
After pull down this panel a bit, and separate connecting wire with product.
Remove cover pipe and cover side
1
Remove two screws(for fixing cover pipe)
2
Pull up the cover side of desired connecting direction, then
cover side is separated.
3
In case of connecting direction is left or right, path through
the hole of cover side.
CAUTION
!
After removing the pipe hole, cut the burr
for safety.
Drain hose junction
1
Remove the rubber stopple of desired direction of drainage.
2
As the following picture, Insert drain hose in the handle of
drain pan, and join drain hose and connecting hose.
Panel Front
Connector
Pipe hole
NOTE
!
When connecting pipe path through rear
wall, don't remove the hole.
Adhesive
Connecting
part
Drain
hose
Panel Front
Connector
Only one
desiring direction
rubber cap